Paneele mehrschichtig

  • Hello all,

    is there a possibility to create panels with several layers? So in the concrete case I need a 2mm aluminum sheet in raw on the inside, then 2x 12.5mm gypsum board, then 20mm rigid foam board and finally an 8mm ESG-H glass facade panel on the outside. The layers should then also be distinguishable from each other with different hatchings when you draw a cut through.

    From time to time, bullet-resistant and fire-retardant panels also need several layers. Aluminum sheet>Surface adhesive>Steel sheet>Surface adhesive>Promatect>Surface adhesive>Aluminum sheet, so if you could also specify the adhesive thickness it would be perfect. Partly it has to be applied with a notched trowel, so it has a similar thickness as compressed tile adhesive.

    Or is there an "alternative trick"?

    Thank you very much for the help.

    This post has been automatically translated.

  • Interesting topic,

    Is there any feedback from Orgadata on this yet?

    This post has been automatically translated.

  • Hello SebastianL.,

    this should be possible in a future version.

    This post has been automatically translated.

Hello! It looks like you like the forum, but you haven't signed up or registered yet.

After you create an account, you can comment on posts and you will be notified when someone replies to you. You can also mark posts that you like.